BISON EPOXY METAL 24ML

DESCRIPTION

EPOXY METAL
DOUBLE SYRINGE 24 ML (BLISTER)
Ironclad and metallic two-component epoxy adhesive. For repairs under extreme conditions.
PROPERTIES
Extreme strength: up to 220 kg/cm²
Metal colored
Resistant to harsh conditions
Resistant to temperatures between -40°C and 100°C
Filling
(Sea)water resistant
Very good chemical resistance
Can be sanded, filed, drilled and painted after curing
SUITABLE FOR:
Ideal for strong repairs of metal objects which must withstand extreme conditions (forces, vibrations, (sea)water, heavy load), such as tools, car parts, engines, (motor)bikes, metal (garden) fencing and cutlery. Also suitable for sealing a small hole in a radiator. Suitable for bonding of metal (steel, aluminum, iron) together and in combination with stone, wood, concrete, and various synthetics (such as Formica, polyester, and Bakelite).
BEFORE USE:
Working conditions
Only apply at temperatures between 5°C and 35°C. Product cures by mixing the resin and hardener.

Personal safety
Preferably wear gloves.

Surface requirements
The materials to be bonded must be dry, clean, free of dust and grease.

Preliminary surface treatment
Degrease parts to be bonded with acetone. Roughen smooth surfaces (sandpaper).

Tools
Mix the components in the double-syringe by means of the supplied mixing bowl and spatula.

DURING USE:
Handling of packaging
Remove the spatula from the side of the double syringe, and the closure cap from the handle. Break the seal of the double syringe.

Directions for use
Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a synthetic spatula until a mixture is obtained with a homogeneous color. Apply the mixture, which at room temperature ( 20°C) remains toolable for about 45 minutes, as a thin layer on one of the two materials. Join the materials and keep them in place for 10 hours. Be careful not to move the parts before the adhesive has cured. After use, clean the nozzle with a cloth and place the special cap in the handle on the double syringe. Resin and hardener must not come into contact with each other unless for usage.

Advice
Some types of synthetics can not be joined such as polyethylene and polypropylene. This can be tested by holding a glowing copper wire against the synthetics. Does it smell of wax? Then you can not bond it.
Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.
Points of attention
After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance, it is important to create a larger amount of adhesive and mix it very well. Curing time depends on temperature. The adhesive does not cure below 5°C.

AFTER USE:
Stains/residue
Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Storage conditions
Store cool, dry, frost-free, upright (nozzle upwards) and tightly closed.